Gastroback 41400 Design Mincer - Manual (Page 6)

22
• Never clean or operate the appliance or parts of the appliance with abrasive or hard
sharp-edged items. Never put the appliance or parts of the appliance in the
dishwasher for cleaning!
• Do not use the appliance if it is damaged or parts of the appliance are damaged. Do
not use the appliance if it does not function properly or if it was excessively loaded. The
appliance is likely damaged if the appliance or parts of the appliance show cracks, exorbi-
tant wearing down, alterations or leaks. It is also likely damaged if the drive wheel of the
motor housing moves slowly. Take the appliance for technical maintenance and repair to
an authorised service centre.
• Never use force assembling or disassembling the appliance. The single parts should be
easily put together. Only operate the mincer after it has been carefully assembled. Never
use the crossed-blade knife and grinding disc in combination with the chopper attachments.
Only use either the crossed-blade knife with the grinding disc or the chopper attachments
at once.
• For the case that the worm housing or the closing ring loosen while operating turn
off the appliance immediately and pull the plug. Operate according to the instructions
›Troubleshooting‹ before turning the appliance on again.
• Always turn the appliance off, wait for the motor to stop moving and then pull the plug
before disassembling the mincer.
• Never push the food into the feeding tube with your fingers. Always use the feedstick
for this purpose! The mincer can not mince hard or stingily ingredients (for example:
bones, nuts, ginger). If you use hard ingredients like onions or carrots, you have to steam
them before adding them to the meet otherwise they can block the motor. If the motor
is blocked turn off the appliance immediately and operate according to the instructions
›Troubleshooting‹.
• Before the mincer is used for the first time, all parts – with the exception of the motor
block – must be thoroughly cleaned in warm soapy water.
• To ensure that the mincer does not seize, never operate it under excessive pressure.
• Instantly switch off the mincer if the worm or knife get blocked by a hard object and
wait for approx. 6 seconds to be certain that the motor is no longer running. Switch on the
mincer after it has been cleaned.
• Never use force operating the appliance to avoid damage of the units of the appliance.
• Never hold your face or other body parts over the feed tube when the motor is running
because little pieces of food could be thrown out of the feed tube.
• Take care handling the crossed-blade knife because it is very sharp.
• Never put foreign substance or hard objects into the feed tube.
• Never repair the mincer yourself. If you discover or suspect a fault, send the mincer
immediately to an authorised service centre for competent examination and repair.
• Store and use the appliance in a clean, frost free environment where it is protected from
dampness, moistness and immoderate and extraordinary burden (such as: downfall, beat,
overheating, moisture in the motor block).