Gastroback 41400 Design Mincer - Manual (Page 12)

Disassembling the appliance
WArNING:
To avoid injury and damages of the
appliance turn the appliance off and then wait for
approx. 6 seconds to be certain that the motor is
no longer running. Always pull the plug before you
start disassembling or cleaning the appliance.
1. Switch off the mincer and disconnect the power supply
cable from the mains. Check that the motor has completely
stopped.
2. Detach the worm housing from the motor block.
3. Unscrew the closing ring turning it counterclockwise.
TIP: If the closing ring is screwed on to tight you can use a screwdriver as shown in the
fig. 10.
4. Remove the grinding disc. If necessary insert a knife or screwdriver between the grinding
disc and the worm housing to pry out the grinding disc.
5. Remove the crossed-blade knife and pull out the worm or if you used the chopper attach-
ments remove them.
TIP: If the tools are stucked knock the mincer carefully on a stable cutting board. The grind-
ing disc should be facing up.
ATTENTION: Be careful not to damage your bench top, the cutting board or the mincer.
6. Remove meat residues.
Operate as described:
ATTENTION: Never put the appliance or parts of the appliance in the dish-
washer or use abrasives for cleaning! This will cause discoloration and
corrosion.
7. Wash all parts thoroughly in hot soapy water. Do not use aggressive detergents. The
parts are not suitable for dishwasher. Soak parts with desiccated food leftovers a few min-
utes in warm soapy water and use a nylon cleaning brush or cleaning sponge for cleaning.
Rinse all parts with running water and dry them accurately.
WArNING: Ensure that the switch and cable do not come into contact with water!
Should this inadvertently happen, all parts must be completely dry before the appliance is
used again. Never let water or other liquids run into the motor housing. Never clean the
power cord or the appliance in the dishwasher, poor liquids over the appliance or douse
or dip it in water or other liquids. In case that water or other liquids ran into the appliance
while operating turn off the appliance immediately, pull the plug and dry the appliance
with a clean cloth.
8. The motor block must only be wiped clean with a moist cloth. Do not clean the motor block
under flowing water, nor should it be immersed in water! Do not use alcohol, benzine, etc.!
9. Grease the grinding disc and crossed-blade knife with food-grade oil.
28