ETS-Lindgren HI-6100 Field Monitor - Manual (Page 67)

Commands in FM5004 Mode | 67
Command Response
Sample Rate SMPR,00
The sample rate is probe-dependent and
set run as fast as possible.
System Alarm,
Hard Probe Failure
—
System Alarm,
Momentary Probe Failure
—
Display Update Rate DUPR,5
The display update rate is fixed at
7 samples/second.
FM5004 Commands
IEEE 488.2 C OMMANDS
Command Description
*CLS Clear status
*DDT Device trigger
*ESE Event status enable
*ESR Event status register
*IDN Identification query
*OPC Operation complete query
*RST Reset
*SRE Service request enable
*STB Read status byte