ETS-Lindgren HI-6100 Field Monitor - Manual (Page 65)

Commands in FM5004 Mode | 65
Appendix D: Commands in FM5004 Mode
Unsupported Commands in FM5004 Mode
The following commands are not supported in either the HI-6100 mode or the
FM5004 mode. In general, the HI-6100 Field Monitor does not have alarm or
analog output capabilities. Functions to adjust the LCD and the display have also
been removed.
A LARM F UNCTIONS
Alarm functions are not available on the HI-6100. These commands
are included for test software compatibility purposes only and have no
effect on the HI-6100. An error entry will be added to the
CONTROLLER COMMUNICATIONS error list.
Command Response
Alarm Latch Where m is equal to the alarm mode:
ALAT,m,0
Alarm Silence Where m is equal to the alarm mode:
ALOE,m,0
Alarm Lower Enable —
Alarm Lower Value Where m is equal to the alarm type:
ALOV,m,0
Alarm Upper Enable Where m is equal to the alarm type:
AUPE,m,0
Alarm Upper Value Where m is equal to the alarm type:
AUPV,m,0