ETS-Lindgren HI-6100 Field Monitor - Manual (Page 50)

50 | Remote Operation
Remote Commands
The commands described in the following pages are available to the user for
remote communications with the HI-6100. The following conventions are used:
1. A lower case x in the command or returned data syntax represents a
numeric value.
2. A lower case n in the command or returned data syntax represents a
channel number (1 through 4) associated with a system probe.
3. A lower case m in the command or returned data syntax represents a
mode selection.
—Read Probe
Writes the current probe field values to a remote port.
Syntax: RPRB,x
Parameters: (x)
0 = Reads all channels 3 = Reads channel 3
1 = Reads channel 1 4 = Reads channel 4
2 = Reads channel 2
5 = Reads minimum, maximum and
average of all active probes
Output format: xx.xxuuuuuuoca,xx.xxuuuuuuoca,,
Each axis or channel data block consists of a fourteen-character string. The first
comma-separated data block is the sum of all axis followed by X, Y, and then Z
axis.
The over/under range character will be blank, U or O. The axis character will be
c,x,y,z or blank.