ETS-Lindgren HI-6100 Field Monitor - Manual (Page 55)

Remote Operation | 55
—Channel Enable
Used to set a channel on or off.
This command should not be used to toggle a channel on and off
frequently. Probes may require several seconds to reinitialize.
Syntax: CHAN,m,n
Parameters: Channel number (m) on/off (n):
1 = Channel 1 3 = Channel 3
2 = Channel 2 4 = Channel 4
To enable channel 1: CHAN,1,1
—Local Mode
Returns the HI-6100 to local mode when it is in remote mode. Local mode allows
the operator to use the front panel buttons.
Syntax: LOCL,x
Parameters: Local mode enable (x)
0 = Local mode disabled 1 = Local mode enabled
To return the HI-6100 to local mode (front panel buttons become
operational): LOCL,1