ETS-Lindgren HI-6153 Electric Field Probe - Manual (Page 98)

98 | Series H-491198-48 Battery Charger for NiMH Batteries
D ISCHARGING A B ATTERY
To discharge a battery:
1. Make sure the power switch on the probe is set to the OFF position or
the battery will not charge.
2. Connect the battery charger to the electrical mains, and then connect
the charger output to the charger jack on the probe.
3. Press the DISCHARGE button on the battery charger. The battery will
fully discharge, and then fully recharge. The total time required to
discharge and recharge is approximately seven hours.
S PECIFICATIONS
B ATTERY C HARGER S PECIFICATIONS
The battery charger may be powered by standard line voltage (110–240 VAC,
50–60 Hz) or by an optional automobile cigarette lighter plug (12.5 VDC).
NiMH Battery:
 4.8 volt 4 cell NiMH Battery,
25 mAH (rapid charge cells,
1.2 volts/cell)
 ETS-Lindgren Part #H-491193
Power
Main: IEC filtered AC power input module
110-240 VAC, 500 mA max,
50-100 Hz
Alternate: Automobile cigarette lighter to 2 mm
power plug adapter cord, 12.5 Vdc,
100 mA
Fuses: 250 volt, 1.0 Amp, Type T
(5 mm x 20 mm)