ETS-Lindgren HI-6153 Electric Field Probe - Manual (Page 100)

100 | Series H-491198-48 Battery Charger for NiMH Batteries
R EPLACING THE F USE
Disconnect the battery charger from power
before replacing a fuse.
If the battery charger fails to operate, check for a blown fuse inside the power
entry module. A blown fuse must be replaced with the same value and type of
fuse, or an unsafe condition may result. Use only 250 Volt, 1.0 Amp, Type T
(5 mm x 20 mm) fuses.
To replace a fuse:
1. Two fuses are located in the fuse drawer in the power input module.
Use a screwdriver to open the drawer.
2. The fuse towards the outside of the drawer is the spare. Remove the
spare fuse from the module.
3. Replace the blown fuse with the spare fuse.
4. Slide the fuse drawer back into the module. Make sure that the drawer
snaps securely into its locked position.