Elecraft DL1 - Manual

E
L E C R A F T
DL1
W I D E B A N D D U M M Y L O A D
R e v C , A p r i l 1 9 , 2 0 1 1
The Elecraft DL1 is a general-purpose wideband 50-ohm dummy load that can be used with an Elecraft or
other manufacturer’s transceiver for test purposes. The DL1 also includes a diode detector that can be used
to measure power output. The chart on the next page indicates the voltage measured at TP1 for various
power levels. Other power levels can be calculated from the voltage measured at TP1 using the following
formula:
P(watts) = (V + 0.25)
2
/25 where V= volts and 0.25 is the RF voltage drop across the diode.
Specifications
Power
Rating 20 watts maximum.
Bandwidth Input VSWR less than 1.1, 0 to 30 MHz
1.2, 0 to 144 MHz
1.3, 0 to 225 MHz
Power Measurement Accuracy 10%, typical, 1 watt to 20 watts
Assembly

Do an inventory of all parts in the kit .
Parts List
1 Dummy Load Printed Circuit Board
8 100 ohm 3 Watt Resistors
1 0.01 uF Ceramic Capacitor
1 Right angle PC–mount BNC Connector
1 1N5711 Diode
4 Self-Adhesive Mounting Feet

Install J1, the BNC connector in the position indicated on the PC board silkscreen

Install the eight (8) 100-ohm resistors in positions R1 to R8. Space the resistors about 1/16 inch
(1.6mm) above the PCB. A piece of scrap printed circuit board, a Popsicle stick, or similar object
can be used as a spacer. Turn the board over and trim the resistor leads. Save two of the resistor
leads for use in the next step.

Using two cut resistor leads create two 1/8 inch (3.2mm) wire U-shaped loops. Install these loops in
the holes provided at TP1 and at the GROUND symbol. These will be used to connect a high
impedance voltmeter to measure power.

Install D1 in the position indicated on the PCB. Make sure the banded end of the diode matches the
silkscreen outline on the PCB.

Install C1 in its indicated position.

Turn the PCB over and install a mounting foot in each corner.