Elecraft XV 432 Assembly Manual Errata User Manual
Xv432 assembly manual errata

Page 1 of 1
XV432 ASSEMBLY MANUAL ERRATA
R e v . D - 3 , N o v e m b e r 2 7 , 2 0 1 3
M A K E T H E S E C O R R E C T I O N S T O Y O U R
M A N U A L B E F O R E Y O U B E G I N A S S E M B L Y .
1. Page 12, Parts Inventory, U7: Change part number to "RA30H4047M1". This is now a metal shielded unit.
2. Page 13, Parts Inventory, R13: The value may be either 25 or 50 ohms.
2. Page 15, Parts Inventory, First Item (FL1, FL2): Add note: “These filters are supplied pre-mounted on the
XV432 RF printed circuit board.”
3. Page 28, Right Column, 7th step to end and Page 29, Left Column, first 3 steps: Because FL1 and FL2 are
already installed, relay K7 cannot be held in place using a book as described. Install K7 by holding it in place
with one finger while “tacking” it in place with a drop of solder on your iron on a pin at each end. After
confirming that it is flat against the pc board, solder the remaining pins, then go back and re-solder the first two
pins as necessary.
4. Page 29, Left Column, first step, delete duplicate sentence: “Solder just two diagonally opposite corner pins
on each relay.”
5. Page 30, Left Column, second step: The value of R13 may be either 25 ohms or 50 ohms.
6. Page 32, Right Column: Delete the last three steps. These filters are pre-mounted on the RF pc board.
7. Page 40, Figure 39: The RF Power Module part is now marked "RA30H4047M1".