Md (mode, get and set), Mt (memory recall tune, set only) – Elecraft KAT500 Serial Command Reference User Manual
Page 12

20
K15
2100
10
K14
1000
08
K13
480
04
K12
230
02
K11
110
01
K10
50
It may take a few tens of milliseconds after issuing Lxx; SET before the relays are changed, and they may
not all be changed at the same time.
SET may be ignored if the current transmit power exceeds the AKIP power threshold.
Inductor relays are released whenever the bypass relay is in bypass (BYPB), and SET has no effect.
MD (Mode, GET and SET)
GET format: MD;
SET/RESPONSE format: MDB; or MDM; or MDA;
MDB; is “Bypass” mode. The bypass relay is released to its Bypassed setting and the KAT500 does not
attempt to tune.
MDM; is “Manual” mode. The KAT500 recalls memorized tuner settings from prior tune efforts on
frequency and antenna change, frequency change, and when the TUNE pushbutton is pressed. A TUNE
button press is also used to search for a match setting. See also the MTM command.
MDA; is “Automatic” mode. The KAT500 recalls memorized tuner settings on frequency change, and if
the SWR exceeds a threshold value (typically 1.8:1) that can be set with the ST command. See also the
MTA command.
SET may be ignored while transmitting.
MT (Memory Recall Tune, SET only)
SET format: MT fffff; where fffff is a frequency, in kHz.
MT performs a “memory recall tune” by changing to the memorized tuner setting for the current
antenna.
If fffff is zero or missing, the last Transmit frequency is used. If the ATU detects a current transmit
frequency, the measured frequency is used instead of fffff.