Elecraft PX3 Owners Manual Errata - Manual (Page 2)

Page 2 of 2
7. Page 37, Parts List, Front Panel Board, E850624: Delete the note that reads:
“One pin has been cut on the 40-pin connector on the reverse side.
This is intentional.”
A few early boards had an unused pin cut off. It is left in place on later boards.
8. Page 38: Parts List; Change the description of the threaded nylon standoff (E700306) from 4-40
to 2-56 thread.
9. Page 44, Figure 32: Add a #2 split ring lock washer under the screw used to secure the power
supply board.
10. Page 43, Figure 30. Add the following directly under the figure:
Be sure you have mounted the plastic bezel on the OUTSIDE of the front panel as shown
in Figure 30.
11. Page 45, Figure 34. Add the following directly under the figure:
If the side panel does not fit as shown, be sure you have mounted the plastic bezel over
the display screeen on the OUTSIDE of the front panel as shown in Figure 30.