EFCO 5800 Series - Manual (Page 14)

9/2000
PAGE 12
included in the cost of the materials for the job.
NOTE: Temporary retainers are available from EFCO by request only and are not
REQUIREMENTS AND CAN FAIL UNDER
RETAINERS DO NOT MEET STRUCTURAL
only, and are not intended to be left
for short term temporary applications
NOTE: Temporary retainers are intended
unattended or overnight. (TEMPORARY
STRUCTURAL LOADS.)
Depending on your sequence of installation, you may or may not want to
retainers and insert permanent gaskets as specified in the following instruc-
If, and when, permanent glazing is possible, remove the temporary glazing
tions. Depending on weather conditions and considering public safety, it is
recommended that the temporary glazing retainers only be used for short
periods of time.
SECTION VIII: EXTERIOR GASKET INSTALLATION
STEP #1 TEMPORARY GASKET INSTALLATION
STEP #2 PERMANENT GASKET INSTALLATION
use temporary glazing retainers to hold the glass in place until the final
gasket installation can be achieved. To allow for temporary installation,
12" long gasket retainers can be provided for your use. Temporary retainers
should be positioned in the center of any glass edge that is less than
30" long and at quarter points for edges over 30".
TYPICAL GASKET INSTALLATION
AT THE TIME OF FINAL GLAZING
ASSEMBLY.
PERIODS OF TIME ONLY.
SHOULD BE USED FOR SHORT
12" LONG TEMPORARY GASKETS