Step #1 install glazing materials – EFCO 5800 Series User Manual
Page 13
PROJECT SHOP DRAWINGS.
BLOCK EVEN WITH THE
FRONT OF THE MULLION
POSITION THE SETTING
TONGUE.
9/2000
bite should be 9/16" in a 2 1/2" wide system. Push the infill completely
back against the interior gaskets.
POSITION THE ANTIWALK
OF THE VERTICAL GLASS
OPENING. SILICONE THE
INSTALLED.
AFTER THE GLASS IS
BLOCK INTO POSITION
BLOCK AT THE CENTER
THE HORIZONTAL SETTING BLOCKS
MUST BE POSITIONED AT 1/4
POINTS OR AS SPECIFIED IN THE
Verify that all gasket retainer pockets are free from dirt and foreign
matter. Place the specified setting blocks and antiwalk blocks as shown in
the approved project shop drawings. Set the specified glazing infill into
the corresponding opening, ensuring positive bearing on the setting blocks
and an equal glass bite at all sides of the infill panel. The typical glass
SECTION VII: GLAZING INSTALLATION
STEP #1 INSTALL GLAZING MATERIALS
PAGE 11
- Windows Hung General Maintenance Instructions (19 pages)
- Windows Hung Understanding Condensation (6 pages)
- Windows Hung Installation (58 pages)
- E-Lite (19 pages)
- E-Shade (41 pages)
- 2 1/2" Center Tongue Sun Shade Clip (19 pages)
- S5500 Advanced (46 pages)
- S5500 Inside Glazed (48 pages)
- S5500 Outside Glazed (48 pages)
- S5500 Router & Jig (6 pages)
- S5500 SSG Captured (81 pages)
- S5500 SSG (53 pages)
- S5600 Concealed Vent (13 pages)
- S5600 Inside Glazed (29 pages)
- S5600 Outside Glazed (26 pages)
- S5600 Slope Glazed (23 pages)
- S5600 Structural Glazed (28 pages)
- S5900 Inside Glazed (18 pages)
- S5900 Outside Glazed (16 pages)
- S5900 Structural Glazed (23 pages)
- 5500X Outside Glazed (60 pages)
- Duracast Pressure Plate (12 pages)
- 8700 Series Assembly Instructions Vol.1 (35 pages)
- 8700 Series Assembly Instructions Vol.2 (34 pages)
- 8700 Series Assembly Instructions Vol.3 (28 pages)
- 8700 Series Assembly Instructions Vol.4 (44 pages)
- 8700 Series Assembly Instructions Vol.5 (89 pages)
- 8700 Series Assembly Instructions Vol.6 (16 pages)
- 8700 Installation Instructions (68 pages)
- 8750XD (43 pages)
- 875X Wall Vent (31 pages)
- 401 Series Roto Vent for Storefront (14 pages)
- 401 Series Storefront (94 pages)
- 406 (T) Series (41 pages)
- 433 Series (90 pages)
- 525 Series (45 pages)
- 526 Series (50 pages)
- 960 Series (65 pages)
- WV410 (21 pages)
- 403X Series (29 pages)
- 406X Series (25 pages)
- 945 Series (50 pages)
- 955 Series (45 pages)
- 901 Series (52 pages)