Dynojet Tuning Link - Manual (Page 14)

Tuning Link User Guide
C H A P T E R 2
Main Window
2-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MAIN WINDOW
The Main window is shown during each of the three modes of tuning. The RPM,
Throttle Position, and Air/Fuel values will change depending on which tuning mode is
chosen. A description of all window functions and displays follows.
Figure 2-1: Main Window
Menu Choices—Many of the software features can be accessed from the menu
choices at the top of the Main window; some features are accessed directly from the
current window. For detailed information on the menu choices, refer to “Menu
Choices” on page 2-6.
RPM, Throttle Position, and Air/Fuel Actual and Target Values—These values
indicate the actual readings along with the target readings during tuning.
• In Warm Up mode, target throttle position and target air/fuel will have no
values.
• In Steady State mode, throttle position and RPM values will change colors and
all three readings are visible.
• In Roll-on Mode, RPM and air/fuel values are always green.
Note: The tuning mode will always be marked in the Mode menu. Select Mode to
verify the current tuning mode.
target values
load control
indicator light
status settings
port status
indicator/warning lights
menu choices
actual values
shift warning
indicator light
advanced/basic
status
previous/next buttons
open loop
indicator light