Dynojet Tuning Link - Manual (Page 29)

S O F T W A R E F E A T U R E S
Basic Software Features
Version 2 Tuning Link User Guide
2-17
• When the Max Steady State TP is set to zero, or any value smaller than the current
cell, the software will tune the current cell and move to the cell directly below the
current cell and continue moving vertically down each column.
Figure 2-15: Steady State Tuning—Max Steady State TP Set To Zero
R OLL -O N F UEL M APPING
Select Mode ! Roll-On Fuel Mapping
Roll-On Fuel Mapping, or Roll-On Tuning, allows you to quickly tune the major
portions of the map using similar techniques to the roll-on runs that you are
accustomed to using in WinPEP to measure power and torque. This type of tuning
closely simulates driving conditions and tunes an entire RPM range at any throttle
position.
1
Set the starting point of the roll-on by clicking on the appropriate cell in the grid.
The software will hold the bike’s RPM just slightly below your start point. Once
your TP matches the target TP, the software will wait for a short time (to allow the
state of the bike to settle) and then allow the bike to accelerate at the rate you set
in the Configuration window.
Figure 2-16: Roll-On Tuning—Set Acceleration Values
config window—max
steady state TP value
set to zero
tune current cell
tuning will continue vertically
down each column
acceleration values set in
the configuration window