Dynojet 250i: Control Panel Interface Upgrade (S/N 202xxxx) - Manual (Page 16)

14
37. If you have an air brake, install P/N 76950110 cable into P7 in the Control Panel Interface board and
run the short cable to the Breakout board as shown and connect. Cable tie as shown and route the
other end to the air brake solenoid. Strip back the wires to the brake air solenoid and crimp into the
barrel connections on the P/N 76950110 Air Brake cable. If you do not have an air brake, then skip
installing this cable.
76950110 Air
Brake cable
Connect here
Strip back and crimp
to barrel connectors