Dynojet 250ix: Pre-Installation Guide - Manual (Page 47)

P O W E R R E Q U I R E M E N T S A N D I N S T A L L A T I O N
Locations Using 50 Hz Power (Locations other than North America and Japan)
Version 3 Pre-Installation Guide for Model 200i/250i, 200iP/250iP, 250iX, and 250iPX Motorcycle Dynamometers
B-9
T ESTING FOR C ORRECT V OLTAGES
You must test the receptacle for proper voltages before the dyno is connected to the
outlet.
Using a voltmeter that is capable of measuring AC voltage, measure between the
points listed below and verify that the correct voltages are present.
Figure B-3: Test the Wall Receptacle
probe 1 probe 2 desired voltage measurement
1 3 220V to 250V
2 box <5V
1
2
3