Dynojet 250ix: Pre-Installation Guide - Manual (Page 29)

D Y N O P R E - I N S T A L L A T I O N I N F O R M A T I O N
Model 250iPX Dynamometer
Version 3 Pre-Installation Guide for Model 200i/250i, 200iP/250iP, 250iX, and 250iPX Motorcycle Dynamometers
21
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MODEL 250IPX DYNAMOMETER
The following specifications and requirements will help you set up your dyno area
and verify you have met the requirements necessary to operate your dyno safely.
P IT S PECIFICATIONS
Before proceeding, take a moment to look over the pit dimensions and requirements
for your in ground dyno. Refer to the pit dimensions (P/N 98229104) you received
from your salesman for more detailed specifications.
Note: The pit must be provided with exhaust ventilation at a rate of not less than
1CFM per ft.2 of floor area (26CFM for the 250iP pit) taken from a point 300 mm
(12 in.) off the floor of the pit at all times that the building is occupied or when
vehicles are parked over this area.
C HASSIS S PECIFICATIONS
description specifications
Length
with standard carriage allow 304.80 cm (120.00 in.)
with extended carriage allow 355.60 cm (140.00 in.)
iPX drum module 76.20 cm (30.00 in.)
pit covers 137.16 cm (54.00 in.)
Height
from bottom of dyno to top of dyno 45.72-46.67 cm (18.00-18.38 in.)
from top of pit to drum guard 5.40 cm (2.13 in.)
from top of pit to top of tire carriage 50.64 cm (16.00 in.)
Width
dyno with upgrade 271.42 cm (106.86 in.)
pit covers with eddy current brake 310.29 cm (122.16 in.)
Weight
model 200iP drum module/crated dyno 725 kg (1600 pounds)/817 kg (1800 pounds)
model 250iP retarder module/crated dyno 953 kg (2100 pounds)/1,089 kg (2400 pounds)
200iPX/250iPX drum module/crated 136 kg (300 pounds)/363 kg (800 pounds)
Drum
diameter 45.72 cm (18.00 in.)
width 50.80 cm (20.00 in.)
diameter, 200iPX/250iPX upgrade 45.72 cm (18.00 in.)
width, 200iPX/250iPX upgrade 55.88 cm (22.00 in.)
Frame structural steel
Maximum Speed 322 KPH (200 MPH)
Maximum Motorcycle Length (front of front
wheel to center of rear wheel)
standard carriage 213.00 cm (84.00 in.)
extended carriage 256.54 cm (101.00 in.)
Remote Switches remote software control