Dave Smith Instruments POLY EVOLVER KEYBOARD - Manual (Page 32)

Fre
LFO ove
the (261 Hz, middle C).
ay not respond well to the fastest LFO
speeds, due to speed limitations of the control voltages; but they will certainly
gener
ntere
Above 15 pe
quency: 0…150, sync – Sets the LFO frequency. Range 0–150 for unsynced
; speed ranges from slow (30 seconds) to very fast – at 90 (8 HZ, C-2) and ab
speed steps in semitones, up to 150
Note: Some of the analog functions m
ate some i sting sounds.
eds as follows: 0, the sync s
Display Timing Sync
32 Steps Sequence speed divided by 32; i.e. one LFO cycle
takes 32 steps
16 Steps Sequence speed divided by 16
8 Steps Sequence speed divided by 8
4 Steps Sequence speed divided by 4
2 Steps Sequence speed divided by 2
1 Step One cycle per step
1/2 Step Two cycles per step
1/4 Step Four cycles per step
1/8 Step Eight cycles per step
1/16Step Sixteen cycles per step
Shape: see tab
ts the le – Selec LFO waveshape:
Display LFO Shape
T riangle Triangle
Rev Saw Reverse Sawtooth
Sawtooth Sawtooth
Square Square Wave
Random Random – changes once per cycle for
sample-and-hold effects
Amount: 0…100 – Sets the amount of LFO routed to the destination.
ey Sync: When this s K
ti witch is enabled (lit) the Poly Evolver re-starts the LFO each
me a new note is played (Key Sync). Each LFO can be set independently.
estination: see table – see the Modulation Destination table on page 41 for a list of
ossible destinations.
D
p
32