Dave Smith Instruments POLY EVOLVER KEYBOARD - Manual (Page 24)

place of the VS noise. Wave 95 (126 on the VS) is a “blank” wave, which can give
some options while sequencing waves. The Poly Evolver ships with waves 97 – 128
the same as 1 – 32.
Level: 0…100 – Sets the volume of the selected Oscillator.
Glide: Normal 0…100; Finger 02…Finger 100; Keybd Off – Sets the oscillator
Glide rate. Glide can be set independently for each oscillator. Low settings are faster.
Normal Glide covers the range from 1 to 100 (0 is no glide). A “fingered” mode that
only glides when more than one note is held down is selected by setting glide over
100, where it ranges from Finger 02 to Finger 100 (equivalent to glides of 2 to 100).
Note: If you set glide all the way to maximum, it goes to Keybd Off, which has the
effect of disconnecting the selected oscillator from keyboard.
Note: Fingered Glide only works in Mono or Unison key assign modes.
FM: 0…100 – Sets the amount of Frequency Modulation. If Oscillator 3 is selected,
FM is applied to Oscillator 3 from Oscillator 4. If Oscillator 4 is selected, FM is applied
to Oscillator 4 from Oscillator 3. Note that each digital oscillator can FM the other at
the same time for some wild results.
Ring Mod: 0…100 – Sets the amount of Ring (Amplitude) Modulation. If Oscillator 3
is selected, Ring Modulation is applied to Oscillator 3 from Oscillator 4. If Oscillator 4
is selected, Ring Modulation is applied to Oscillator 4 from Oscillator 3. Note that each
digital oscillator can Ring modulate the other at the same time.
Note: If the Ring Mod amount is turned up, you will get output from the Oscillator
even if the Oscillator Level is set to zero.
Shape Seq: Off, Seq1...4 – This parameter allows sequencing Waveshapes. Off if
not in use, otherwise select one of the four sequences Seq 1, Seq 2, Seq3, or Seq 4
to change the waveshape on every sequence step. In other words, if sequence 1 is
selected, with step 1 = 10 and step 2 = 5, then waveshape 10 will play in the first step,
and waveshape 5 will play in the second.
Noise
Level: 0…100 – Controls the volume of white noise mixed into the filter. The same
amount goes into both channels.
External In
24