Dave Smith Instruments POLY EVOLVER KEYBOARD - Manual (Page 31)

Envelope 3
Destination: see table – Sets the Envelope 3 destination. See the Modulation
Destination table on page 41 for a list of possible destinations.
ocity: 0…100 – Sets the amount of MIDI velocity controlling the level of envelope
or to Attack.
f Envelope 3.
elease: 0…110 – Sets the Release time.
FOs
Amount: -99…+99 – Sets the amount of Envelope 3.
Vel
3.
Delay: 0…100 – Sets the delay time of Envelope 3, pri
Attack: 0…110 – Sets the Attack time o
Decay: 0…110 – Sets the Decay time.
Sustain: 0…100 – Sets the Sustain level.
R
L
The Poly Evolver has four identical Low Frequency Oscillators (LFOs). To select a
specific LFO for editing, press the appropriate switch, 1–4. Turning a knob will then
adjust the parameters of the selected LFO. Holding one of the four switches will solo
that LFO (the switch will blink) by setting the Amounts of the other three to zero. It
does not affect any modulation that is routed to
LFO Amounts, though, so at times it
may not completely turn off all other Amounts.
31