Coral Industries Steam Bypass - 2SR1-P (If Purchased from a Plumbing Wholesaler) - Manual (Page 7)

2SR1-P 7/05
10
Towel Bar
(D)
/
Bracket Kit
(E)
Slide sleeves from towel bar bracket kit
(E) onto towel bar brackets. Insert
towel bar brackets into each end of
towel bar (D).
Mount towel bar and pull/stop (E) to door
panel using 8A x 1 1/4" flat head screw
(E). Place pull/stop label in recessed
area of pull/stop, covering screw head.
On opposite end of towel bar, mount
bracket to door panel using 8A x 1" pan
head screw.
Repeat for remaining panel.
Mount towel bars on same side of door
panels as horizontal vinyl seals in top
channels. Mount pull/stops on edge of
panel closest to jambs.
C Header
Jamb
B
8A x 3/8"
Pan Head
Screw
N
Header
C
Bumper
8A x 1 1/4"
Pan Head
Screw
I H
Jamb
B
Position header over jamb with roller track
of header resting on top of jamb. Tape
header to top of opening with masking
tape to hold in place while mounting
remaining jamb.
Position remaining jamb on opposite wall
with bottom resting on sill and top of jamb
inside header. Mount to wall using
8A x 1 1/4" pan head screws (or
8A x 2 1/4" pan head screws for 531
jambs) with bumpers in top and bottom
holes.
From inside of shower, secure header to
jambs by drilling 1/8" hole through header
into jambs. Secure using 8A x 3/8" pan
head screws (N).
OUTSIDE OF BATH
9
Header
(C)
/ Jamb
(B)
8A x 1 1/4"
Flat Head
Screw
Towel Bar
Bracket
Towel Bar
Bracket
Sleeve
Towel Bar E
E
E
Horizontal
Vinyl Seal
D
8A x 1"
Pan Head Screw
E
Pull /
Stop
Label
E
OUTSIDE OF BATH
OVERHEAD OF BATH
Pull / Stop E
Pull / Stop E
Pull /
Stop
E
INSIDE OF BATH