Coral Industries Steam Bypass - 2SR1-P (If Purchased from a Plumbing Wholesaler) - Manual (Page 4)

2SR1-P 7/05
Measure your threshold width and determine the
centerline. Measure wall to wall at tub level on the
centerline. Record the centerline measurement below.
Centerline Measurement
1 Identify Jambs
(B)
BEFORE CUTTING SILL
Identification of your jambs is a critical step. The
cut length of your sill varies depending on the
jambs included in your enclosure.
Locate your jambs (B) and compare to the illustrations.
A901 has an overall width of 1", with short and long legs
on opposite sides.
A531 has an overall width of 1 1/2", with only a slight
difference between length of legs from one side to the
other.
Long
Legs Long
Legs Short
Legs
1" 1 1/2"
Short
Legs
A901 A531
Measure
OUTSIDE OF BATH
Tub
Centerline
CROSS SECTIONS
Your unit has vertical and horizontal vinyl seals pre-installed in the door panels. Door panels are to be hung with
the horizontal vinyl seals in the top channels facing the outside (roller track side) of header.
Vertical vinyl
seals face
legs of jambs.
Vertical vinyl
seals face each
other at the center
of unit.
Jamb
Towel Bar
Door Panel
Jamb
Towel Bar
Door Panel
VERTICAL CROSS-SECTION HORIZONTAL CROSS-SECTION
Horizontal
vinyl seals
face legs of
header.
(Towel bar
will install on
same side)
2 Centerline