Coral Industries Provincial Prestige Swing Door/ILP - 0PJ - Manual (Page 2)

0PJ 6/02
Before starting installation of your new enclosure, carefully read all
instructions and lay out parts to become familiar with their identity.
Do not try to cut the mirrors or glass used in this enclosure. • Tempered glass and mirrors will disintegrate if cut.
CLEANING
SEALING
The use of a caulking compound can assure a water-tight seal when applied along outside edge of the enclosure where metal and bath meet.
If desired, caulk inside of enclosure where jambs meet walls.
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure to a fiberglass
unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with a 1/8" drill bit.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes in the tile, lightly
chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors into the holes making certain that
ring on large end of anchor meets the surface of the tile.
USE OF ANCHORS
INSTALLATION INSTRUCTIONS
Measure opening at
threshold of shower and cut
sill (A) to that measurement.
If necessary, file sharp
corners of sill to fit contour of
your unit.
Position sill on center of
threshold with tall edge of sill
toward outside of shower.
Tape sill to threshold with
masking tape to hold in place
while positioning jambs.
Place jamb (B) on sill with short legs against
wall. If necessary, file sharp corners on back
of jamb to fit contour of your unit.
Align jamb vertically using a level and mark
wall through prepunched holes. Remove
jamb and drill where marked using 1/8" drill
bit. Repeat for remaining jamb on opposite
side.
Reposition jambs on wall and secure using
8A x 1" pan head screws (I).
Level
Sill
A
Contour as
needed
Jamb
B
2
8A x 1" Pan
Head Screw
I When anchors (H) are used,
holes should be drilled using
3/16" drill bit. (Use masonry
bit for tile.)
1
Threshold Centerline
Masking Tape
Sill A
File sharp
corners of sill
as necessary
to fit contour
of your unit
OUTSIDE OF SHOWER
Due to the manufacturing process, there may be rack marks present at one end of your sill and
header. All sills and headers must be trimmed to fit individual openings. When cutting sill and
header, make certain to trim off end with rack marks.
Measure
OUTSIDE OF SHOWER
Centerline
OUTSIDE OF SHOWER
Cleaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.