Coral Industries Provincial Prestige Swing Door/DPNL - 5PJ - Manual (Page 6)

5PJ 8/02
14
13
On opening side of door, caulk joint on sill where magnetic door stop and sill meet.
On opposite side, caulk where hinge door stop and sill meet.
Magnetic
Door Stop
OUTSIDE OF SHOWER
Caulk
Sill
Hinge Door Stop
and Door Panel
A
Caulk
The use of a caulking compound will assure a watertight
seal of your enclosure. Apply caulk along outside edge of
enclosure where metal and bath meet, especially where
sill meets threshold.
If desired, caulk inside of enclosure where jambs meet
walls.
C
B
OUTSIDE OF SHOWER
Caulk
Make certain that bottom channel of door is clean and dry before mounting drip rail. After
mounting, drip rail should not be removed or repositioned. Adhesive on tape needs 72 hours curing
time for maximum bond.
Aluminum drip rail may be additionally secured by
drilling with 1/8" drill bit through drip rail into
bottom channel. Attach using 8A x 3/8" truss head
screws. When drilling in door panel, make sure drill
does not hit glass. Glass is seated approximately
1/2" into channel.
With door in closed position, place drip rail on bottom
channel of door on inside of shower. Position so that
bottom edge of sweep extends approximately 1/2" below
bottom of door.
Mark location for drip rail, peel protective cover from tape
(M) and press into place.
Insert drip rail plug (P) into groove of drip cap on opening
side of door.
P
Drip Rail
Tape
F
M
INSIDE OF SHOWER
Drip Rail Plug
1/2"
Sweep
extends 1/2"
below bottom
channel.
Door
Panel
Drip
Rail
12
Double
Channel
OUTSIDE OF SHOWER
Sill
A