Coral Industries Provincial Prestige Swing Door/DPNL - 5PJ - Manual (Page 5)

5PJ 8/02
11
10
Secure sill by drilling, from outside of shower,
through sill into double channels. Secure using
8A x 3/8" truss head screw.
Double
Channel
Door
Panel
8A x 3/8 "
Truss Head Screws
D Jamb
A
J
B
Sill
Side
Panel
OUTSIDE OF SHOWER
From inside shower, measure width of door panel
at bottom. Drip rail (F) should be 1/2" shorter
than door width. If longer, cut to proper length.
Slide vinyl sweep (N) into slot on back of drip rail.
Trim ends even with edges of drip rail.
Smooth cut end of drip rail fin with a file to remove
sharp point.
Drip Rail
Sweep
Measure
N
F Drip Rail
Contour
INSIDE
OF SHOWER
9
Connector Screw
with Washer
M
INSIDE OF SHOWER
Exterior
Handle
L
Interior
Handle
Push / pull handle kit (L) comes with parts
assembled in the order they will be once
installed on glass. Loosen allen screws on
interior handle to disassemble parts.
Place bushings in holes of glass. Trim so that
bushings are flush with glass surface. Place
one washer on each connector screw. From
inside surface of glass, insert connector
screw through hole, backing with another
washer on outside of glass. Hold exterior
handle in place on outside of glass and secure
by tightening connector screws.
On inside of glass, slip interior handle over
connector screws. Secure in place by
tightening allen screws on interior handle.
Bushing
Washer
Allen Screw
K
Allen
Wrench