Coral Industries 6000 Pivot Door with Adjustable Jambs - 763R - Manual (Page 2)

763R / 713R -GP 4/06
PARTS LIST
Before starting installation of your new enclosure, carefully read all instructions
and lay out parts to become familiar with their identity.
USE OF ANCHORS
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure
to a fiberglass unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with
an 1/8" drill bit.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes
in the tile, lightly chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors
into the holes making certain that ring on large end of anchor meets the surface of the tile.
CLEANING
SEALING
The use of a caulking compound can assure a water-tight seal when applied along outside edge of the enclosure where metal
and bath meet. If desired, caulk inside of enclosure where jambs meet walls.
C leaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.
Do not try to cut the mirrors or glass used in this enclosure.
Tempered glass and mirrors will disintegrate if cut.
TOOLS
NEEDED
1/8" Drill Bit
3/16" Drill Bit
(3/16" Masonry Bit for
Ceramic Tile)
Scratch Awl
Measuring Tape
Hacksaw
Phillips Screw Driver
Caulking Compound
File
Drill
Level
Masking Tape
Hex Head Wrench
A SILL A263 1
B PIVOT JAMB A960 1
C STRIKE JAMB A730 1
E ADJUSTABLE JAMB A265 1
D DRIP RAIL A710 / V667 1
F DRIP RAIL SWEEP * VS91 1
I DRIP RAIL TAPE (I) HT52 1
H MAGNETIC STRIP H170 1
J PIVOT DOOR SLIDE BLOCK (I) HPT3 2
W PIVOT VINYL (I) V517 1
P DRIP RAIL PLUG HA28 1
G PIVOT PLATE HA65 2
K PIVOT PIN (I) HPHD 2
L NYLON WASHER HW81 1
M 8-32 X 1/2 HEX HEAD SCREW HP05 2
N 8A X 3/8 PAN HEAD SELF-DRILLING SCR H900 8
O PULL HANDLE KIT (II) HSAD
EXTERIOR PULL HANDLE HA31 1
INTERIOR PULL HANDLE HA32 1
6-32 X 1 1/4 PAN HEAD SCREWS H485 2
R ANCHORS H002 6
Q 8A X 1 1/4 FLAT HEAD SCREW H810 6
DESCRIPTION KEY PART QTY
FRAME PACKAGE
* Optional (I) Pre-Installed (II) May be Pre-Installed
HARDWARE BAG PARTS