Code 3 V-Con Siren - Manual (Page 2)

2
Introduction
The 3600 series electronic siren has been designed to meet the needs of all emergency vehicles. This series of sirens incorporates
the popular packaging and features of the V-CON siren with completely new MOSFET technology. Specifications are subject to
change without notice.
Standard Features
The 3690 series sirens consist of integrated controls and amplifier in a single package with 7 circuit lighting controls available as well.
The models are as follows:
3672 - Primary Tones: Wail, Yelp, HyperYelp, Air Horn
- Secondary Tones: HyperYelp, Yelp
3692 - Primary Tones: Wail, Yelp, Hi-Lo, Air Horn
- Secondary Tones: Yelp
3696P - Air Horn, PA & Radio Rebroadcast only
3622 - Same as 3692 but 24 Volt rated
2
Sirens are an integral part of an effective audio/visual emergency warning system. However, sirens are only short
range secondary warning devices. The use of a siren does not insure that all drivers can or will observe or react
to an emergency warning signal, particularly at long distances or when either vehicle is traveling at a high rate
of speed. Sirens should only be used in a combination with effective warning lights and never relied upon as a
sole warning signal. Never take the right of way for granted. It is your responsibility to be sure you can proceed
safely before entering an intersection driving against traffic, or responding at a high rate of speed.
The effectiveness of this warning device is highly dependent upon correct mounting and wiring. Read and follow
the manufacturer’s instructions before installing this device. The vehicle operator should check the equipment
daily to insure that all features of the device operate correctly.
To be effective, sirens must produce high sound levels that potentially can inflict hearing damage. Installers
should be warned to wear hearing protection, clear bystanders from the area and not to operate the siren indoors
during testing. Vehicle operators and occupants should assess their exposure to siren noise and determine what
steps, such as consultation with professionals or use of hearing protection should be implemented to protect
their hearing.
This equipment is intended for use by authorized personnel only. It is the user’s responsibility to understand
and obey all laws regarding emergency warning devices. The user should check all applicable city, state and
federal laws and regulations. Code 3, Inc., assumes no liability for any loss resulting from the use of this warning
device.
Proper installation is vital to the performance of the siren and the safe operation of the emergency vehicle. It
is important to recognize that the operator of the emergency vehicle is under psychological and physiological
stress caused by the emergency situation. The siren system should be installed in such a manner as to: A) Not
reduce the acoustical performance of the system, B) Limit as much as practical the noise level in the passenger
compartment of the vehicle, C) Place the controls within convenient reach of the operator so that he can operate
the system without losing eye contact with the roadway.
Emergency warning devices often require high electrical voltages and/or currents. Properly protect and use caution
around live electrical connections. Grounding or shorting of electrical connections can cause high current arcing,
which can cause personal injury and/or severe vehicle damage, including fire.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER USE OF EMERGENCY
WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY OF EMERGENCY PERSONNEL AND THE
PUBLIC.
SIREN PRODUCTS