Code 3 V-Con Siren - Manual (Page 17)

17
A. SUPPLY FUSE OPEN
B. SIREN TERMINAL NEGATIVE NOT
GROUNDED
A. REPLACE FUSE.
B. RECONNECT TERMINAL
NEGATIVE TO GROUND.
PROBLEM PROBABLE CAUSE REMEDY
A. MAXIMUM RADIO REBROADCAST TRIM-
MER MIS-ADJUSTED
B. RRB WIRES NOT CONNECTED TO TWO-
WAY RADIO EXTERNAL SPEAKER
RRB VOLUME LOW, OR NO
RRB AT ALL. VOLUME CON-
TROL FULLY CLOCKWISE.
A. REFER TO SET-UP AND
ADJUSTMENT SECTION
B. CHECK RRB CONNEC-
TIONS
A. REMOTE SWITCH (HORN RING) WIRING
FROM TERMINAL REMOTE SHORTING TO
POSITIVE OR TO GROUND (EARTH).
SIREN SOUNDS BY ITSELF A. CHECK WIRING FOR
ANY SHORTING.
A. VEHICLE CIRCUIT BREAKERS NOT RAT-
ED PROPERLY, AND ARE OVERHEATING,
OR ARE NOT FUNCTIONING PROPERLY
A. REFER TO SPECIFICA-
TIONS SECTION, PAGE 18.
USE A BREAKER WITH 1.25x
THE AMPERAGE RATING
FOR THE WATTAGE BEING
USED.
POWER DISTRIBUTION SEC-
TION NOT WORKING
SIREN RUNS PROPERLY
BUT SHUTS DOWN WHILE
RUNNING, THEN STARTS
RUNNING AGAIN AFTER A
FEW MINUTES