Code 3 Matrix - Manual (Page 16)

16
Additional Lighting Installation
(ex. Smart 3x5, Arch Beacon, etc.)
If a smart light head is to be sync’d with the system, power, ground, and sync wires are all that are needed.
1. Attach power wires through power switch for vehicle lights.
2. Attach sync wire to sync connection in Matrix System Central Controller box.
Flash Patterns
In the Matrix System Central Controller, the flash patterns are split into two sections: rate & sequence. A
flash rate example would be Double Flash 75, Quad Flash 150, Single Flash 250, etc. Once the rate is set,
the sequence can be chosen. A flash sequence example would be Front/Back Lights, Driver/Passenger
Lights, Opposite Corners Lights, etc. Below is the order in which they can be selected when programming
the unit:
Flash Rates
1. Single Flash 75
2. Double Flash 75
3. Triple Flash 75
4. Quad Flash 75
5. Five Flash 75
6. Single Flash 150
7. Double Flash 150
8. Triple Flash 150
9. Quad Flash 150
10. Five Flash 150
11. Single Flash 250
12. Single Flash 375
Flash Sequences
1. Front/Back
2. Driver/Passenger
3. Opposite Corner/Corner
4. Rotate Front & Flash Back
5. Rotate Front & Driver/Passenger Back