Code 3 Matrix - Manual (Page 11)

11
3. Attach conduit and fitting through hole in the rear of the stainless steel enclosure and secure with
nut.
Make sure conduit and fitting are installed in the hole on the back side of the stainless steel enclosure to
protect the harnesses from rubbing on the enclosure during normal use.
4. Feed the blunt cut end of harnesses through the conduit and fitting.
5. Continue feeding through the vehicle and into the cab.
6. Cut the cable to length long enough to make all connections inside the Matrix System Central
Controller box.
Attaching Harnesses for 3x5 and XT-3 to the Matrix System Central Controller
1. Push the harness through the black bushing on the box. It is easiest to push through before
stripping back the sleeve or adding the quick connects.
2. Pull in plenty of the harness to allow for running wires to their final destination.
3. Once through the bushing, the sleeve can be stripped and quick connects can be added. Strip
jacket enough to allow plenty of room for the wires to move about inside the Matrix CC box but
leave enough of the jacket so that it still covers the wires for about an inch after entering the box.
Harnesses should not hinder opening the lid of the box.
4. Strip individual wires to prepare them for crimping.
5. Crimp the quick connects onto each wire.
6. Attach each quick connect to its proper location inside the Central Controller box.