Code 3 Citadel Ford PI and Explorer - Manual

Ford Explorer
Brackets by Public Safety Upfitters Patent Pending
Citadel
Installation Procedure
Tools Needed
13 mm 12 point socket
Torque Wrench
1 Spoiler
2 Liftgate
Raise liftgate disconnect the liftgate molding clips and remove the liftgate molding (Qty:7)
Locate the fasteners attaching the rear spoiler to the shell (Qty:5)
Remove 13 mm 12 point socket (Qty:5)
Pushing up firmly on the rear spoiler, disconnect the spoiler clip as shown in figure 1. (Qty:4)
Raise spoiler away from the vehicle to expose the electrical connector and disconnect
Remove spoiler from vehicle and lay part on a protected surface to prevent scratches
Position Citadel assembly over spoiler studs
Route Citadel wiring along with existing wiring from brake light assembly back through liftgate
Place spoiler on vehicle
Make necessary electrical connections
(Black goes to ground; red to your switched power source and or option, Yellow is used for synchronization and is NOT used in the setting of flash patterns. Blue wire is used for setting different flash
patterns, use chart below for setting flash patterns.
Position the center screw to the spoiler first, followed by the remaining nuts torque the nuts in the same sequence
Torque nuts to 6 Nm (53 lb in)
Fig 1.