BoonDocker YAMAHA: Nytro Turbo - Manual (Page 4)

BoonDocker – 1585 Hollipark Dr. Idaho Falls, ID 83401 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381
Revised 2-13-08 Copyright © 2004-2008 by Boondocker Page 4 of 20
F. Jumper/Battery Connector - The jumper can be used in
one of the following two ways:
1. A 9-volt battery can be plugged into the jumper and the
jumper can be plugged into the female connector
(pressure transducer connector must be unplugged) to
power the Control Box. This allows the Control Box to
be turned on when the engine is off.
2. If the Control Box is unplugged from the injector harness,
the jumper can be plugged in its place into the
Boondocker injector harness (9-volt battery is not
required). This reconnects the injectors to the ECU,
bypassing the Control Box. This is for emergency or
diagnostic use only! Do not use nitrous or allow engine
to build boost as no extra fuel will be added and engine
can be damaged!
III. Control Box Mounting Location
The Control Box can be mounted on the panel below the
handlebars. The box can also be mounted under the hood, on the
dash, or on the handlebars (with custom bracket as shown).
Before applying the adhesive strips, thoroughly clean each surface
(rubbing alcohol works well). It is also best if each surface is
room temperature or a little higher.
If the box is mounted under the hood, keep the box away from
excess heat, including radiant heat. Also keep the box away from
the ignition coils.
IV. Control Box Operation
The control box is powered only when the injectors are on which occurs for a few seconds when the key is first turned on
or when the engine is running. Up to 5 different fuel-adjustment maps are stored in the box (currently all with zero values).
The box will remember which map was last selected and what its settings are – you do not need to do anything to save a
map when making adjustments (see Fuel Adjustments below).
A. Intro / Startup Screen
When the box is first turned on (by the engine or battery), the Intro screen is displayed. Press any key to go to the
main menu. An example Intro screen display is shown below:
FX Nytro Turbo .
4B5iBD N2O:FIX
In the example shown above, this screen displays the following information:
FX Nytro Turbo
Sled model and application. This box is designed for the Yamaha Nytro with a
turbocharger. Boxes for other sleds will have other lettering.
4B5iBD
This is the software version of the box. The box can be reprogrammed only by sending
the box back to Boondocker
N2O:
Shows that this Control Box is nitrous capable.
FIX
Nitrous pressure regulator type (refer to Nitrous Section for more description)