BoonDocker ARCTIC CAT: HIJACKER 2.0 - Manual (Page 3)

A 9v battery and cable is included in the package. When plugged into the two wire button connector the battery will power the
Hi-Jacker. This allows for operation of the Hi-Jacker II while the snowmobile engine is off.
DO NOT PLUG IN THE BATTERY WHILE THE ENGINE IS RUNNING
Pressing any button on the Hi Jacker will advance from the STARTUP SCREEN to the MAIN MENU
For all menus, the current selection is shown by the arrow and underscore (shown
below the F). Use the arrow keys on the keypad to move the cursor. Move the cursor to
the desired selection and press the “SEL” key to select the desired menu option.
Selecting the #?? option from the MAIN MENU will allow for adjustment of the machines
boost and horsepower output.
STARTUP SCREEN
MAIN MENU
BOOST ADJUSTMENT MENU
Operating Instructions
PSI
Adjusting the PSI number will adjust the total amount of boost the machine produces. Note this number does not represent
additional boost added by the box it is the total amount of boost produced.
Btn
Adjusts the amount of boost added when the button is pressed
Idle
Adjustment for Idle fuel. This value can also be adjusted in the FUEL MENUS
Note: Don’t set your horsepower plus the BtnAdd (+PSI) amount to a value higher than your fuel octane will support. Pay care-
ful attention to the machines octane warning and detonation codes.
BoonDocker tollfree: 877-522-7805 local: 208-542-4411 fax: 208-524-7381 www.boondockers.com 3