BoonDocker ARCTIC CAT: HIJACKER 2.0 - Manual (Page 2)

1. Remove the side-panels, remove the two torx screws next to the upper a-arms on each side of the machine, remove the
two torx screws on the belly side of the front nose cone, remove the plastic wire-ties securing the air filter on the clutch
side of the machine, un-hook the dash wiring harness then slide the hood forward and remove the hood.
2. Route the Hi-Jacker wiring harness through the opening in the upper cowl next to the reverse beeper.
3. Plug-in the Hi-Jacker to the stock connectors on the machine. Refer to the diagram for the location of four plug-ins on the
machine.
4. Remove the fuel tank cowl and locate the rubber boost line exiting the manifold. This line is located in between and
below the TPS and MAP sensor. Cut this line and install the supplied brass “T” fitting. Use two 4” zip ties around spliced
connection to secure the boost line.
5. Run the boost line from the brass “T” fitting to the push to connect fitting on the Hi-Jacker.
6. Route all wiring and poly line out of the way of moving parts and excessive heat. Secure all wiring using the supplied zip-
ties.
Throttle Position Sensor
ECU
Boost Vent
Wastegate Solenoid
Handlebar Button
Hi-Jacker Harness
MAP Sensor
Manifold Boost Line
Boost Line
EFI
sel
Stock Wiring Harness
Arrows represent
Installation Instructions
BoonDocker tollfree: 877-522-7805 local: 208-542-4411 fax: 208-524-7381 www.boondockers.com 2