Catler JE 4011 - Manual (Page 15)

13
OPERATING YOUR JE 4011 JUICE EXTRACTOR
Step 5
Press the ‘On/Off ’ switch on the control panel
to ‘On’. The juicer will start to operate at the
selected speed. The speed can be changed
at any time during the juicing process by
adjusting the variable speed control dial.
After 3 minutes, the LCD display will
automatically turn off if the ‘On/Off ’ switch is
not turned ‘On’, or a speed is not selected.
NOTE
Step 6
With the motor running, place food into the
feed chute and use the food pusher to gently
guide food down.
To extract the maximum amount of juice,
always push the food pusher down slowly.
The JE 4011 Juice Extractor will automatically
stop operating if the motor is stalled for more
than 10 seconds. This is a safety feature.
Either too much food is being processed at
one time or the pieces are not small enough.
Try trimming food, cutting food into smaller
pieces of even size and/or processing a smaller
amount per batch.
To continue juicing, reset the Juice Fountain
Plus by pressing the ‘On/Off ’ switch on the
control panel to ‘Off ’, switch off at power outlet
and remove power cord from power outlet,
then clear the feed chute, fi nally plug power
cord back into power point and switch on at
power outlet. Turn the appliance back on by
pressing the ‘On/Off ’ switch to ‘On’.
NOTE
Step 7 - Using the Juice Extractor
As fruit and vegetables are processed, juice
will fl ow into the juice jug and the separated
pulp will accumulate in the pulp container.
The pulp container can be emptied during
juicing by turning the JE 4011 Juice Extractor
‘Off ’ at the control panel and then carefully
removing the pulp container. Replace the
empty pulp container into position before
continuing to juice.
Do not allow the pulp container to overfi ll as
this may aff ect the operation of the appliance.
To minimise cleaning, line the pulp container
with a plastic freezer bag to collect the pulp.
Pulp can then be used in other dishes (see
page R8 - R9), or as compost for the garden or
discarded.
To include the froth in with your juice, simply
remove the lid of the juice jug when pouring
juice into the glass.
NOTE
Step 8 - Using the Puree Extractor
When using the Puree Extractor Puree will
fl ow into the juice jug. There will be no pulp
extracted into Pulp Container.
Some fruit Puree may be left in the juice
collector. This is normal. The amount left over
will vary depending on ripeness and hardness
of fruit.
NOTE
WARNING: NEVER USE FINGERS, HANDS OR OTHER UTENSILS TO PUSH
FOOD DOWN THE FEED CHUTE OR TO CLEAR THE FEED CHUTE DURING
OPERATION. ALWAYS USE THE FOOD PUSHER PROVIDED.