Salter Brecknell B220 - Manual (Page 5)

5 B220 Counting Scale User’s Manual
Introduction
Installation
The unit must be
plugged into a properly
grounded outlet that is
within easy access
from the scale location.
Short key press = 1
beep
Long key press = 2
beeps
Sleep Mode
Error Messages
This manual covers the operation of the B220 parts
counting scale by Salter Brecknell. Major sections of the
manual begin with black barred text as seen above.
Minor section headings appear in the left column along
with important notes and warnings.
Place the unit on a firm, level surface that is free from
drafts and vibration. Place the unit in a location ergo-
nomically suited for the user.
Level the scale using the adjustable footpads. Center
the bubble in the bubble level located below the Salter
Brecknell logo on the front panel.
Plug the power adapter to an appropriate power source.
See note at left. The display will perform a self-test and
then show the normal display mode.
To put the unit to sleep, long press the I/O key. See
note on short vs. long key presses at left.
To wake up the scale, short press the I/O key.
Below are examples of various error messages you may
see. If a persistent error message appears, disconnect
then reconnect power to the unit. If problem persists,
contact your local authorized Salter Brecknell distribu-
tor.
Temporary error Weight unsteady
Over range Under range
Balance failed