B&M 80841 PRO RATCHET SHIFTER - Manual (Page 7)

7
to figure 3. Avoid kinks and sharp bends and
route the cable away from hot engine or
exhaust parts.
Remove the two rubber boots, one large
nut, and a large lockwasher her from the
threaded end of the shifter cable. Slide the
end of the cable into the cable bracket, Install
large nut and lockwasher loosely over end of
cable. Install two rubber boots onto end of
cable. Install the swivel on the threaded end
of the cable and position it in the center of the
threaded portion.
STEP 35. Move the transmission selector
lever by hand to full rear position (LOW).
Operate the shifter lever to the low gear
position (ratcheted all the way back). Adjust
the large nuts on the cable so that the swivel
will slide into the hole in the selector lever that
is labeled "B&M 2". See figure 9. Tighten the
large nuts completely. Be sure that the swivel
will slide freely in and out of the hole in the
selector lever. Note: The shifter will not
operate correctly unless the B&M2 hole
in the shift lever is used.
Manual valve guide plate
Cable bracket
mounts on outside
of oil pan
Detent roller spring
Selector lever
pinch bolt
Manual valve
Note that pin on
selector lever fits in
groove in valve.
B&M shifter lever
B&M selector
shaft
Figure 9
Use this hole for B&M
Pro Ratchet, Quick
Silver, Star Shifter, Z-
gate, or Quick Click
Use this hole for Hurst
shifter and B&M Ban-
dit shifter
Use this hole for Turbo
Action shifter
Figure 8
Use this hole for B&M
Pro Stick, Megashifter
or Street Stick
PERIODIC INSPECTION AND MAINTENANCE OF YOUR SHIFTER
IS RECOMMENDED TO ENSURE THAT THE MECHANISM IS WELL
LUBRICATED, FREE FROM DIRT OR RUST AND THAT THE CABLE
IS PROPERLY ADJUSTED. LACK OF MAINTENANCE COULD RE-
SULT IN A FAILURE INCLUDING A FAILURE OF THE REVERSE
LOCKOUT SAFETY FEATURE.
WARNING