B&M 80690 MEGASHIFTER - Manual (Page 3)

3
Figure 4
Remove this blocker
pin and the two e-
clips for GM four
speed transmissions
Figure 3
Indicator
cable
E-Clip
Bracket Sheet metal
screw (2)
the threaded end of the shifter cable.
Slide the end of the cable into the cable
bracket. Install the large nut and the
lockwasher loosely over the end of the
cable. Install the two rubber boots onto
the end of the cable. Install the swivel
on the threaded end of the cable and
position it in the center of the threaded
portion.
STEP 13. Move the transmission se-
lector lever by hand to the full rear
position (Low). Operate the shifter le-
ver to the Low gear position (ratcheted all the way back). Adjust the large nuts
on the cable so that the swivel will slide
into the front hole on the selector lever.
Tighten the large nuts completely. Be
sure that the swivel will slide freely in
and out of the hole in the selector lever.
Note: The shifter will not operate
correctly unless the front hole in
the shift lever is used.
Leave the swivel out of the hole and
move the selector lever to Park, all the
way forward. Also move the shifter to
the Park position (all the way forward).
Reinsert the swivel into the front hole
in the selector lever. Check to see that
the swivel will slide freely in and out of
the front hole in the selector lever in
this position. If it does not slip in freely,
adjust the swivel slightly until it will slip
into the hole in the lever.
Move the shifter back to the Low
gear position and check that the swivel
will still slide easily in and out of the
front hole in the selector lever. (If you
do not use the front hole in the lever, it
will be impossible to correctly adjust
7.50"
1.00"
11.75"
TRIM AS
REQUIRED
Figure 2
Washer (2)