B&M 45074 PRECISION SPORT SHIFTER - 88 - 00 HONDA User Manual
Page 2
STEP 8. Gently pull the shift lever from
the change extension (the dust seal
and the shift lever ball seat should also
come out). Only the 10mm change ball
bolts, nuts and change extension will
be re-used.
ASSEMBLY
STEP 9. Thoroughly clean the inner
shift socket portion of the change ex-
tension and lightly lubricate this area.
STEP 11. Insert the B&M Short Throw
Shifter into the change extension
socket. Re-install the two change ball
bolts and lock nuts, making sure the
square portion of the bolt is fully seated.
Tighten to 7 lb-ft.
STEP 12. Reinstall the change exten-
sion and shifter back into the vehicle.
Note that the shifter must be carefully
guided into the shift lever dust seal to
keep it from ripping the seal - take your
time.
STEP 13. Remount the front of the
change extension to the transmission
and tighten the bolt to 16 lb-ft.
STEP 14. Replace the two bolts in the
rear extension mounting rubber and
tighten to 16 lb-ft.
STEP 16. Honda Civic/CRX, 1990-93
Integra: Using the two smaller Teflon
bushings, insert them into both sides
of the shifter. Swing the change rod up
and align the shifter so they slide to-
gether, being careful to not damage the
bushings. Insert the bolt and tighten
the nut to 16 lb-ft.
1994-up Integra: Take two of the
larger Teflon
bushings and insert them
into both sides of the shifter. Swing
the change rod up and align the shifter
so they slide together, being careful to
not damage the bushings. Insert the
bolt and tighten the nut to 16 lb-ft.
STEP 17. Reconnect the two rubber
exhaust hangers.
STEP 18. Carefully lower the vehicle
Parts List
1 B&M Short Throw Shifter
2 Bushing, Teflon
(large)
2 Bushing, Teflon
(small)
1 Instruction Sheet
Tool List
10mm Wrench
10mm Socket and Drive
12mm Wrench
12mm Socket, Drive, Extension
Several clean rags
Hydraulic Jack or Hoist
Jackstands or Wheel Ramps
and install the shift knob. Slide the
shifter through each gear, checking for
binding or rough movement. If the shifter
does not move smoothly, raise and
support the vehicle and check that the
bushings are properly seated and that
the linkage does not bind.
change extension
change rod
change ball lock nuts
('94+ Integra only)
Teflon
bushing (large)
Teflon
bushing (small)
B&M Short Throw
Shifter assembly
or
change ball bolts
(Civic/CRX & '90-'93 Integra)
Teflon
bushing (small)
(Civic/CRX & '90-'93 Integra)
Teflon
bushing (large)
('94+ Integra only)
or