B&M 40504 BRACKET AND LEVER KIT, 4R70W User Manual
Page 5
STEP 12. Verify inner shift lever moves through
every position.
STEP 13. Replace the oil fi lter. We recommend that
you use a new fi lter unless the vehicle has very low
mileage. Replace the oil pan gasket with a new
gasket. Replace the original bolts except for the
two that secure the cable bracket. The cable bracket
is installed with the supplied bolts with spacers
between the bracket and the pan. Tighten the oil pan
bolts to 12-16 ft-lbs.
TOOLS: Torque Wrench, Drive, Extension,
& sockets (10 & 13mm).
STEP 14. With selector shaft in neutral position,
Install Neutral Position Sensor. (NOTE:
replace Neutral Position Sensor in same
orientation as found before removal).
Align sensor to neutral position before
tightening two (2) 8mm bolts.
* Use selector lever to rotate Selector
Shaft to neutral position.
STEP 15. Secure B&M Selector Lever onto B&M
Selector Shaft with M10 bolt and M10
washer.
TOOL: Wrench (17mm).
- 10225 SHIFT IMPROVER KIT (7 pages)
- 10227 TRANSPAK (8 pages)
- 50231 TRANSKIT (1 page)
- 10230 FLEXPLATE (1 page)
- 10280 CAST DEEP PAN (2 pages)
- 10300 DEEP PAN, CHRYSLER NAG-1 (3 pages)
- 10310 CAST ALUMINUM FRONT END COVER FOR DANA 30 IS CONSTRUCTED OF A356.0-T6 ALUMINUM. THIS RUGGED UNIT DIS (2 pages)
- 10311 CAST ALUMINUM REAR END COVER FOR DANA 35 WAS DESIGNED TO STRENGTHEN THE REAR END BY PREVENTING CASE (3 pages)
- 10312 Dana 44 Rear End Cover, A356.0-T6 Aluminum (3 pages)
- 10314 DANA 60/70 COVER WAS DESIGNED TO FIT BOTH DANA 60 AND DANA 70 DIFFERENTIALS. CONSTRUCTED OF A356.0-T (3 pages)
- 10315 Dana 80 cover was designed to strengthen the axle by preventing case distortion, ring gear & cap bea (3 pages)
- 10497 BRACKET & LEVER KIT (1 page)
- 117101 STRT TRANS TH700R4 CHV WITH MECH SP (7 pages)
- 120001 SHIFT PLUS 2 TRANS CONTROLLER (19 pages)
- 120002 TPS FOR CARBUERETED KITS (2 pages)
- 20260 SHIFT IMPROVER KIT (6 pages)
- 20261 SHIFT IMPROVER KIT (6 pages)
- 20280 CAST DEEP PAN (2 pages)
- 20297 KICKDOWN SWITCH KIT (1 page)
- 20480 NITROUS HOLESHOT 2400 (6 pages)
- 22300 NAG-1 Locking Trans Dipstick (2 pages)
- 30228 TRANSPAK (8 pages)
- 30262 SHIFT IMPROVER KIT (8 pages)
- 30280 CAST DEEP PAN (2 pages)
- 35229 TRANSPAK (8 pages)
- 35265 SHIFT IMPROVER KIT (8 pages)
- 35498 BRACKET AND LEVER KIT (2 pages)
- 40227 TRANSPAK (18 pages)
- 40263 SHIFT IMPROVER KIT (16 pages)
- 40281 CAST DEEP PAN (1 page)
- 40291 CAST DEEP PAN (2 pages)
- 40295 CAST DEEP PAN (2 pages)
- 40297 CAST ALUMINUM REAR END COVER, FORD 8.8 (3 pages)
- 40298 Cast Aluminum Rear End Cover for Ford 9.75 (3 pages)
- 40422 HOLESHOT 2400 C6 SMALL PILOT (6 pages)
- 40496 BRACKET AND LEVER KIT (3 pages)
- 40497 BRACKET AND LEVER KIT (2 pages)
- 40505 BRACKET AND LEVER KIT, 4R100/E40D (7 pages)
- 45034 PRECISION SPORT SHIFTER - 08 & UP CORVETTE C6 & Z06 (11 pages)
- 45043 PRECISION SPORT SHIFTER - O4 + GTO (10 pages)
- 45043 PRECISION SPORT SHIFTER - O4 + GTO (1 page)
- 45044 PRECISION SPORT SHIFTER - C5 &C6 CORVETTE (15 pages)
- 45047 PRECISION SPORT SHIFTER - 88 - 00 HONDA (2 pages)
- 45048 PREC SHIFTER JEEP 99-01 JEEP WRANGL (12 pages)