AVer SF1031W - Manual (Page 16)

8
2.3 Connect Power and Power On Camera
Connect the external power adapter to the DC power input connector located on the camera’s rear panel, and
then connect it to your wall outlet. You can confirm the power source is supplied from the Power LED on the
camera.
2.4 Reset Camera
To reset the system settings to factory defaults, please follow below steps:
1. Make sure the power status of camera is ON.
2. Press the reset button about 6 seconds.
3. And then, release the reset button.
4. The camera will automatically reboot. Upon restarting the camera loads the factory default configuration
settings.