AVer EB3004_MD User Manual

Page 35

OSD MENU

Description

EVENT SETUP

ALARM SETTING
SENSOR SETTING
MOTION DETECTION

ALARM SETTING

Configure parameters of alarm.

ALARM CONTINUOUSLY
ALARM PERIOD

ALARM TYPE

SELECT / DESELECT ALL
SENSOR

RECORD

MOTION DETECTION
VIDEO LOSS
HDD FAIL

005 SEC

ALARM SETUP

ALARM TYPE

Select the way of alarming – RECORD or RELAY.

ALARM CONTINUOUSLY

Enable/disable to execute the alarm action (ALARM TYPE)
continuously when alarm has been trigger. The alarm action is
according to the setting of ALARM TYPE that user has setup.

- When

ALARM CONTINUOUSLY has been started, it

won’t be stop until the recording has been stop
manually.

- If

ALARM CONTINUOUSLY has been enabled, the

ALARM PERIOD won’t be able to configure.

ALARM PERIOD

Set the amount of time (in seconds; 0~ 999) for stop alarm
action after alarm has been reset.

If ALARM CONTINUOUSLY has been enabled, the
ALARM PERIOD won’t be able to configure.

SELECT/DESECLECT ALL

To enable/disable all below selections.

SENSOR

Enable/disable to send out the alarm when sensor has been
triggered.

MOTION DETECTION

Enable/disable to send out the alarm when motion has been
detected.

To activate the motion recording, please enable the
Motion Detection feature here and setup record mode
as ALARM RECORD in

RECORD SCHEDULE

VIDEO LOSS

Select the channel that will send out the alarm when video is
lost.

HDD FAIL

Enable/disable to send out alarm when hard disk is failed.