AVer EB3004_MD - Manual (Page 29)

25
3.1 Menu Function
Use remote control to navigate in the OSD menu. The red frame turns yellow when you are
making a selection.
Each time you change the video display output or video system (NTSC/PAL), the power
must be turned off and on to reset the DVR unit.
OSD MENU Description
MAIN MENU
CAMERA/RECORD
SCHEDULE
EVENT SETUP
DISPLAY
STORAGE
SYSTEM
CAMERA/RECORD SETUP
Configure camera parameters, name and PTZ camera.
CAMERA / RECORD SETUP
GENERAL
CHANNEL SETTING
PTZ
CHANNEL NAME
GENERAL SETUP
GENERAL SETUP
RECORD MODE
TIME STAMP
DVR NAME
WATERMARK
AUTO RECORD
CIF
COMPANY
RECORD MODE
Three type of recording mode -- D1/CIF/D1 Enhance.
Under D1 mode, the total recording frame rate is 60/50fps
(NTSC/PAL). The video recording is in full screen resolution
and takes turns from one channel to the next one when Auto
Scan enables. Each channel is recorded only at a maximum
frame rate of 30/25 fps (NTSC/PAL). User can switch to view
the video in single full screen or QUAD screen.
In D1 ENHANCE mode, the total recording frame rate is
30/25fps (NTSC/PAL). Each channel can be recorded at a
maximum frame rate of 30/25 fps (NTSC/PAL).
Whereas in CIF mode, the total recording frame rate is
120/100fps (NTSC/PAL). The video recording is at a lower
resolution, but all channels can be recorded at a maximum
frame rate of 30/25 fps (NTSC/PAL). User can switch to view
the video in single full screen or QUAD screen.
DVR NAME
Assign a name for the DVR unit. Maximum is 10 characters
that may contain A~Z, 0~9, !, “, #, $, %, &, ‘, (, ), *, +, -, /, :, ;, <.
>, ?, @, and space.
TIME STAMP
Enable/disable the time and date display on the each channel.