AVer System Contrll Pro quick guide User Manual
Page 7
5
QUICK USER GUIDE
5. Connect the RS232 cable to the RS232 port of the RS485 to RS232 converter.
6. Connect another side of RS232 cable to the RS232 port of the DVR/CMS server.
7. Power on the System Controller.
8. The following figure is an example of the installation illustrate.
9. After hardware installation has completed, please remember to enable the System Controller
function on DVR system.
RS485 port to RS485 port Directly
This way of installation is suitable for SA9000E Pro, SA6000E RACK, SA9416 RACK, and
SA6032E RACK.
Before starting to make a connection, please prepare the following items:
RS232 cable
Single core wire
1. The DVR server should power on and DVR program is executed.
2. Cut the 4 lines of single core wire. The length of single core wire depends on the distance
between DVR and System Controller.
3. Using the screwdriver to press down the orange tenon and insert the single core wire cable into
the pin hole of the I/O terminal on the System Controller. When the wire cable is inserted in the
end of the pin hole, release the orange tenon to fix the wire cable. The following table is the pin
hole match for DVR server and System Controller.