AVer System Contrll Pro quick guide - Manual (Page 14)

12
Switching to 485 CMS Mode
When the System Controller is connecting with CMS server through the 485 port, the System
Controller mode should be in 485 CMS modes in order to operate the CMS system. If the mode is
not 485 CMS mode, please follow the below steps to switch to 485 CMS mode.
i - The default mode is USB CMS mode
- The 485 PTZ and 485 DVR mode doesn ’t support for CMS server.
- Please remember to setup the System Controller Pro 485 as System Controller model
on CMS server.
1. In main menu, press and select (system controller setting).
2. In System Controller setting screen, select .
3. In Mode screen, select the . If the current mode is 485-CMS mode already, then the
selection will not show in selection list.
Current System
Controller Mode