AVer SA series User Manual
Page 68
60
(9) Miscellaneous
Enable the conditions in Miscellaneous section you want the system to perform.
- Status Report
Send a daily system event and attention analysis report. To change the e-mail settings, click Setup.
- Beep if no signal
Make sound when the video signal is lost.
- Mandatory Record
Always record video when software is running
- Enable Overlay
To enhance video signal for better video quality.
- Screen Saver
Set a period time to enter screen saver mode when system idle.
- Auto Scan Period
Set the time gap of the Auto Scan function from 3 to 10 seconds. This automatically switches to the next
video in cycle depending on the set time gap.
- Temperature Display
Select the format of temperature -- °C or °F
- Playback Mode
Select the mode of playback the video.
Select date and time: Select the date and time which user wants to playback.
Play the last file: Automatically playback the video from the last hour
Instant Playback: Automatically playback the video which has just recorded. To set the instant
playback time period, fill in the time in second at Set Instant Playback
’s Play Time column.
- Date Format
Select the date format which wants to display in Select date and time playback mode
(10) POS
Set from which camera screen to display the data from the POS equipment. Click Setting, to set the POS
Console Setting. (see also
(11) UPS (Uninterruptible Power Supply)
Protect the system from damaging, such as power surges or brownouts. This automatically gives time to
close the DVR system properly when the battery backup power has reached the Shutdown when capacity
below percentage level setting. The UPS device must be connected to your computer (see also
).