Canon IV-S2 - Manual (Page 28)

Pull out the Take-up Spool,* and slide
the read/-cut-leader end up under the
Take-up Spool Clip as far as it will go.
The glossy side of the film should face
the spool. Make sure that the per­
forated edge of the film is flush with
flange of the Take-up Spool. Do not
wind the film around the spool.
With the Take-up Spool in your left
bond and the film magazine in your
light hand, draw out the film about
four inches so that the first two per­
forations ore showing. See diagram
plate inside the camera
Slide both the film magazine and the
Take-up S p o o l evenly and gently into
iheir c o i rect chambers nil the way
dov/n The dull 'emulsion') side of I he
fiI m should he f aci ng the lens.
- J P N . P A T . 3 9 1 9 3 5