Auto exposure bracketing (aeb)l, Auto exposure bracketing (aeb) – Canon EOS Rebel 2000 User Manual
Page 53
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^ Auto Exposure Bracketing (AEB)l
With autoexposure bracketing, the camera automatically changes the
exposure level within the set range for three successive frames. The
bracketing amount centers on the correct exposure and the bracketed
exposures can be varied up to ±2 stops in 1/2-stop increments. The three
bracketed shots are exposed in the following sequence: Correct exposure,
underexposure, and overexposure. Auto Exposure bracketing is useful for
obtaining subtle lighting effects especially with slide film.
THE IIMSE WAS REMOVED DUE
TO COPYRIGHT RESTRICTIONS
THE IMAGE WAS REMOVED DUE
TO COPYRIGHT RESTRICTIONS
THE IMAGE WAS REMOVED DUE
TO COPYRIGHT RESTRICTIONS
Correct exposure
Underexposure (-1.0 stop) Overexposure (+1.0 stop)
Press the Function button and
point the <►> arrow to <‘^>.
Turn the <£Z2i> dial to set the
desired bracketing amount.
• For example, if 1.0 is set, the
underexposed and overexposed
frames will be exposed at -1.0 and
+1.0 stop respectively.
• To cancel autoexposure bracketing,
set the desired bracketing amount to
0.0. The bracketing amount will not
be canceled even if you turn the
Command Dial to .
• The setting takes effect after any of
the following actions:
• The shutter button is pressed halfway.
• The Command Dial is turned.
• Six seconds elapse.
53